these call traces happen constantly and the transfer almost stalls So I just ran a test, writing to an iscsi target hosted on the same box as gluster. Īlso I think its happening outside of Gluster load (if i connect directly to the host via iSCSI, different mount than gluster) but when at idle no errors (or maybe they are so minimal I'm not seeing. Be sure to include all the logs listed above including, L2TP trace options for continued research.MY PROBLEM WAS A DEAD FAN causing overheating everything! memory, chipset. If the problem is still not resolved, contact your technical support representative.For more information, refer to traceoptions (L2TP). For additional L2TP troubleshooting, enable the L2TP traceoptions using “ edit services l2tp traceoptions“.If the L2TPD is down on the router, it can be reactivated using the command: activate services l2tp tunnel-group Troubleshoot the L2TP connection using show services l2tp tunnel brief and show services l2tp session brief, which show the connection state.Review the output of show log l2tpd for tunneling protocol process information.In the show log messages output, examine the messages before and after the L2TPD_SERVER_START_FAILED event message.Investigate the L2TP server side of the connection to see if any changes have been made or if they are having any issues with the server.Perform these steps to troubleshoot the issue: Look for any related events that occurred with or just before the L2TPD_SERVER_START_FAILED message. The errors may also be seen if the UDP port is being used by another application intended for L2TP.Įxamine the following outputs to help determine the cause of this message: show log l2tpd

These errors may be seen when an AIS (Advanced Insight Script) has been added or updated. Jnp_l2tp_server_start: Could not create L2TP server 0.0.0.0:1701 L2TP_DEFAULT_PROTO_CREATE_FAILED: l2tpd: could not create L2TP module Below is an example of the messages: L2TPD_SERVER_START_FAILED: L2TP: Cannot start L2TP server These errors are caused when L2TP cannot bind to the port that the SNMP daemon was sending traps to. The startup of the L2TP server failed to start. L2TP facilitates the tunneling of PPP packets across an intervening network in a way that is as transparent as possible to both end-users and applications. The L2TPD_SERVER_START_FAILED message is reported when the Layer 2 Tunneling Protocol (L2TP) server did not start.

Wd4100 server startup failed 0xd9